Inkjet Printers

How do I resolve the error "Unable to complete request. Retry with fewer pages or with collate off. Press Cancel (5021)" on my all-in-one printer?
This error may occur when copying or scanning a large number of pages (more than 10) using the Automatic Document Feeder with the collate option set to Yes....
Wed, 2 Sep, 2020 at 9:09 AM
How do I install/replace the printhead in my EASYSHARE 5000 Series All-in-One Printer?
If you have an ESP or HERO printer  for instructions on installing the printhead. To replace the printhead in your all-in-one printer:  Make sure the pri...
Fri, 4 Sep, 2020 at 8:10 AM
How do I resolve the error message "Device Disconnected" (106-5002) when scanning from Home Center Software?
Make sure your printer is connected to your computer and try to scan again. If NORTON Firewall is installed on your computer: Open NORTON Internet Securi...
Fri, 21 Aug, 2020 at 5:14 PM
How do I connect my all-in-one printer for faxing?
Notes: Make sure your all-in-one printer is fax capable. Use the fax cable that was included with your printer or functionally operating RJ-11 telephone c...
Thu, 13 May, 2021 at 11:53 AM
How do I manually assign an IP Address for my network-capable all-in-one printer?
Locating the IP Address for your WINDOWS computer: Select  Start > Run and type cmd in the window. The command line window will be displayed. Type  ip...
Thu, 13 May, 2021 at 12:05 PM
How do I set up my all-in-one printer for manual two-sided printing?
Do the following to manually print a two-sided job: Open the document you want to print, and select Print. Select your all-in-one printer. Click Propert...
Thu, 13 May, 2021 at 12:07 PM
How do I resolve the error code 1-2070 that I get when scanning with my all-in-one printer?
To resolve the error code: Determine if there are any other printers (actual or virtual) installed that may be conflicting with your KODAK All-in-One Pri...
Thu, 13 May, 2021 at 12:09 PM
Why is the Wi-Fi light blinking on my all-in-one printer?
The Wi-Fi light blinks when the printer is searching for a connection or when the existing signal is too weak to transmit. If you are connected with a LAN...
Fri, 16 Oct, 2020 at 12:11 PM
How do I turn on bidirectional support on my all-in-one printer?
To turn on bidirectional support:  For computers with WINDOWS XP or VISTA Operating Systems: Select Start > Settings > Printers and Faxes. Righ...
Thu, 20 May, 2021 at 11:16 AM
What should I do if Home Center Software shows that my all-in-one printer is disconnected?
Make sure that your printer is powered on, and that you set up your printer by following the setup instructions included with your printer. NOTE: If you...
Thu, 13 May, 2021 at 12:08 PM