When you connect your all-in-one printer to the wireless network using a BELKIN Wireless G Plus MIMO Router (Part # F5D9230-4), you need to configure your router security to WPA2-AES instead of TKIP.

To resolve this issue:

  1. Make sure your computer is connected to your wireless network.
  2. Type 192.168.2.1 in your Web browser and log on to your router configuration page.
  3. Select  Wireless > Security from the left panel
  4. Make sure:
    • Security Mode is set to WPA-PSK (no server)
    • Authentication is set to WPA2-PSK
    • Encryption Technique is set to AES

      NOTE: Refer to the user manual for your router or contact your network support if you have problems configuring your router.
  5. Select  Apply Changes.
  6. Connect your printer to wireless network again:
    • From the printer control panel, press Home.
    • Select  Network Settings, then press OK.
    • Select  Wi-Fi Setup Wizard, then press OK.
    • Follow the on screen instructions to connect to the wireless network.