When making a WPS connection, your router may not accept the push button verification within the required time limit. 


If a timeout has occurred, to connect your printer to your network:

  1. Press OK on the printer control panel. The Wi-Fi Wizard should list the available networks.
  2. If a list of available networks does not appear, reset the printer:
    1. Turn off your printer.
    2. Disconnect the printer power cord.
    3. Wait 10 seconds.
    4. Connect the printer power cord.
    5. Turn on your printer.
    6. From the control panel, start the Wi-Fi Wizard again, and select your network from the list of available networks.

NOTE: To connect your printer using an alternative method, see the Start Here Guide that was included with your printer.